RC Car Sticker Set, Decals, Liveries For 1/10 Body Shells UK, +50 Designs Pre-cut Drift, Racing, Touring Liveries for all 258-280 Wheelbase Body Shell Liveries comes with transparent transfer tape to help you easily locate and apply your wanted design in place and prevent from cracking or other damages.

 
Application forms:
 
Simply clean your shell from dusts and oils, cut out roughly your wanted decal around, spray on sticky side with soapy water then spray good amount of soapy water on your shell and gently apply your decal or slide around until you get the spot, if sticker doesn't slide gently peel off from one side without sudden moves and by bending it backwards you will take it off without cracking it, to fill in big deep gaps or work around canards we advise to you credit card or sticker applycator tool called ''Squeegee'' to push in the bends or curves and move out air bubbles inside the decals.
 
 
**** Attention! ****
 
Before Applying Decals Must Know:
Never peel off transfer tape until your job is done!
Don't put all together at once!
Don't cut your decal in the air, use firm surface to cut it through without cracking it.
Scissors are not advised to use! (Use DIY Hobby Knife)
Never use heatgun or don't work in hot areas or around toxic hot fumes floating in the air!
Hot weather conditions, heat, fumes or heat gun hot air over 25 degrees of celcius activates the glue which may lead your stickers to become more sticky, dry faster and may ruin your work before it starts. Keep decals in cool area away form direct sun light...
Keep away from children!
Always use a freebies, test kits, or extra decals made as leftovers which are usually supplied to do a test-run for first time decorators.
After all finished put your shell away for 12 to 24 hours for decals to cure in and get best possible results.